Back to Top

Welcome to our new site. Please let us know of any issues.

Handcrafted Ceramic Lighting Fixtures

LVMP04-SG Fossil Mini Pendant Sagebrush

Click on above image to view full picture

  • LVMP04-SG Fossil Mini Pendant Sagebrush
  • LVMP04-SG Fossil Mini Pendant Sagebrush
  • LVMP04-SG Fossil Mini Pendant Sagebrush

Fossil Mini Pendant Sagebrush

Base SKU(s): LVMP04-SG

Availability: In stock

* Required Fields


This small cone is enhanced with a tree-like pattern of incised lines. The glossy Sagebrush glazed finish adds to the beauty and earthy style of the Fossil Mini Pendant. The opaque ceramic shade blocks glare while providing generous energy efficient down-lighting.


Please view related products for additional color combinations. Contact us directly for any custom requests.

Available Size:

  • 3.75"W x 8.75"H


  • Includes hand-glazed ceramic shade, 6' coaxial cable, brushed nickel mono-point canopy with integrated 12V transformer, and MR16 bulb
  • Resistant to rust and corrosion
  • Handcrafted with pride in the USA

CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL INJURY OR DEATH AND PROPERTY DAMAGE. We recommend installation by a licensed electrician. This product must be installed in accordance with applicable installation code(s), by a person familiar with the construction and operation of the product and the hazards involved.* Caution: Do not exceed maximum wattage noted on fixture.

QDF Quick-Jack connector instructions for low-voltage mini-pendants

1. Locate the QDF connector at the top of the coaxial cord. With the provided metric allen wrench, completely remove the set screw from the tip and the base of the QDF connector.

2. Grab the retainer base of the QDF connector and remove it by turning it away from you. Hold the plug of the connector as you do this.

3. You can now identify all three components that make up the QDF connector.

4. Proceed to pull the coaxial cord out and away of all three components.

5. This step requires you to measure the length of the suspension desired and clip the coaxial cord.

6. Once you've clipped the cord, proceed to peel back the coaxial braided jacket about 3/4" from the tip of the insulated center wire and leave as a bundle.

7. Clip off the excess bundle of coaxial braided jacket until you have exposed 3/4" of the insulated center wire. Then, using a pair of wire strippers, remove 1/8" of center Insulated plastic jacket and no more.

8. Twist remaining coaxial braided jacket snugly over center insulated wire; this will allow for a clean insertion into the QDF connector.

9. Insert the cord back into the QDF connector by passing through the retainer and sleeve first. Now hold the tip of the braided outer jack tightly as you turn the plug at the same time. This will allow for better penetration of the cord into the plug. Then, make certain you can see the tip of the center wire at the top orifice of the plug to insure a good connection.

10. This finial step requires you tighten the set screw at the tip of the plug first, re-attach the sleeve and retainer onto the plug second, then tighten the set screw at the base of the retainer.

Write Your Own Review

You're reviewing: Fossil Mini Pendant Sagebrush